Brandt Defoamer ( Qt.) 12/Cs.

Principal Functioning Agents:

Polydimethylsiloxane . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10%
Constituents ineffective as spray adjuvant: . . . . . . . . . . . . 90%
Total: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100%

DIRECTIONS FOR USE

BRANDT DEFOAMER is a high quality silicone based anti-foaming agent designed to prevent foam formation or defeat existing foams in pesticide spray solutions. Excessive foaming can promote inefficiency in spray activities. It may be used on agricultural, forestry, turf and ornamental, industrial, structural and noncropland sites. Read and follow the precautions, restrictions and recommendations on the labels of pesticides used with this product. Use according to the most restrictive label directions for each product in any tank mix. COMPATIBILITY: BRANDT DEFOAMER is compatible with most pesticides. However, if the desired combination has not been previously used, a compatibility test is recommended. MIXING: Shake well before using. Fill spray tank 1/2 full of water and begin agitation. Add product at agitation level with paddles turning and then follow with other ingredients as directed by label or in the following sequence and continue filling tank: (1) Dry flowables or water dispersing granules, (2) Wettable powders, (3) Flowables, (4) Solutions, (5) Emulsifiable concentrates. Alkaline water promotes the degeneration of certain pesticides. Buffer spray tank solution to a pH below 8.0. Continue agitation until spray solution is completely mixed. If spray solution has been allowed to stand, thoroughly agitate and remix before application.

RECOMMENDATIONS: The proper quantity to use will vary with foaminess of spray chemicals, water chemistry, equipment characteristic, method of application, etc. Also, rates of product higher than those below may be used if necessary to reduce foam. However, do not add this product at a rate which exceeds 5% of the finished spray volume.

FOR DILUTE, FULL VOLUME SPRAYS:
As an Antifoaming Agent: Add 1-2 fl. oz. per 100 gallons of water before foaming begins.

As a Defoaming Agent: If foam persists, an additional 1-2 fl. oz. may be required.