Tebuconazole 3.6 F (Gal.) 4/Cs

Active Ingredient: Tebuconazole, alpha-[2-(4-chlorophenyl)ethyl]-alpha(1 ,1- dimethylethyl)-1 H-1,2,4-triazole-l ethanol 38.7%
Other Ingredients: . 61.3%
Total: 100.0%
Contains 3.6 pounds tebuconazole per gallon

DISEASE CONTROL IN GOLF COURSE TURF For use on all Golf turf applications of cool season and warm season grasses (such as Bentgrasses, Bluegrasses, Fescues, Ryegrasses, St. Augustine grasses, and Zoysia) or their mixtures. Tebuconazole 3.6FL FUNGICIDE is not phytotoxic to any of the above mentioned grasses when used in accordance with the label. Note: Bermudagrass can be sensitive to Tebuconazole 3.6FL FUNGICIDE under certain conditions. Do not apply consecutive applications during or just after dormancy break. Avoid applications when temperatures are expected to exceed 85 degrees F. Tebuconazole 3.6FL FUNGICIDE can be used for the prevention and control of the diseases mentioned in table below. Begin applications when conditions favor disease development and repeat applications as long as these conditions persist. Preventative treatments can be applied using 28 day intervals as indicated. When treating golf greens, always treat aprons and approaches. Spray uniformly over the area to be treated with properly calibrated equipment. Apply the specified amount of Tebuconazole 3.6FL FUNGICIDE in sufficient water for thorough coverage. A volume of 66 - 132 gallons per acre (1.5 - 3.0 gallons per 1,000 sq ft) is recommended. Apply using properly calibrated low volume, hand held, mechanical or motorized ground broadcast equipment. Application to small areas may be made with low-pressure handwand or backpack equipment. Maintain constant agitation during application. Depending on the disease, Tebuconazole 3.6FL FUNGICIDE should be watered into the crown and active root zone for best results. Make all applications after mowing and allow foliage to dry thoroughly before irrigation. For best results use spray mixture the same day it is prepared.

Diseases Controlled:

Dollar Spot (Sclerotinia homoeocarpa)
Copper Spot (Gloeocercospora sorghi)
Powdery Mildew (Erysiphe graminis)
Corticium Red Thread (Laetisaria fuciformis)
Rusts (Puccinia spp.)
Brown Patch/Rhizoctonia Blight, Large Patch (Rhizoctonia solani)
Brown Ring Patch (R. circinata)
Anthracnose -Basal and Foliar (Colletotrichum cereal)
Red Thread (Laetisaria fuciformis)
Pink Patch (Limonomyces rosipellis)
Bermuda Grass decline (Gaeumannomyces graminis var. graminis)
Take All Patch (Gaeumannomyces graminis)
Gray Leaf Spot (Pyricularia grisea)
Stripe Smut (Ustilago striiformis)
Spring Dead Spot (Leptosphaeria korrea, L. narmari, Ophiosphaerella herpotricha, Gaeumannomyces graminis)
Necrotic Ring Spot (Leptosphaeria korrea)
Fusarium Patch (Fusarium roseum)
Summer Patch (Magnaporthe poae)
Zoysia Patch, Large Patch of zoysia (Rhizoctonia solani)
Gray Snow Mold/ Typhula Blight (Typhula incarnate)
Pink Snow Mold/Microdochium Patch (Microdochium nivalis)

Application rate:

.6 oz. per 1,000 sq. ft. or 26.5 oz. per acre.

NOTE: Apply the specified amount of SHAR-TEB 3.6FL FUNGICIDE in 1.5 to 3.0 gallons of water per 1000 sq. ft. Make all applications after mowing and allow foliage to dry thoroughly before irrigation. Do not use clippings for animal feed. Do not exceed 3.6 fl. oz of SHAR-TEB 3.6FL FUNGICIDE per 1000 sq. ft. per year. Do not exceed 6 applications per year.